Adjustments - Steel City 20-400 Owner's Manual

wArning
!
Make sure the switch is in the off position and
the machine is unplugged
◊ BLAde CHAnge
We will take the example of a blade change to illustrate
all the settings related to it.
1. Reassemble the eccentric lever.
2. Remove the safety pin and open the protective covers.
2. Clear the ensemble of the ball bearing from the two
guiding devices located above and below the table.
3. Remove the blade,
carefully avoiding rubbing
the teeth on the metal
surfaces.
4. Insert the new blade.
Point the teeth down to
the right of the ribbon.
Replace the pin.

AdjusTMenTs

◊ BLAde Tension
1. Lower the tension lever of the blade and evaluate the
tension exerted found on the scale located behind the
high wheel
To increase the tension, turn the lever (in the vertical
position)
counterclockwise.
Flip the lever down to see the correct setting of the
tension on the scale.
To spare the tensioning spring, when the saw is not in
use, remove the tension and lock the power supply.
◊ CenTer THe BLAde
1. Loosen the lock nut of the handle located on the back
at the same height as the center of the high wheel.
Page 12
clockwise. To
Increase the
Decrease the
tension tension
Counter screw
2. Rotate the wheel by hand to
observe the centering of the blade
on the wheel's rubber.
To move the blade into the
frame, turn the handle clockwise.
To move it out, turn counter-
clockwise.
decrease it, turn
Handle centering the
blade.