Adjustments; Raising And Lowering The Blade; Tilting The Blade - Steel City 45925G User Manual

RAISING AND LOWERING THE
BLADE
Fig. 28
B
The blade height adjustment handwheel and handwheel
lock knob are located on the front of the cabinet above
the blade bevel scale. To raise the saw blade, loosen
the handwheel lock knob (B) (counterclockwise) and
turn the handwheel (A) clockwise. When the saw blade
is at its desired height, tighten the handwheel lock knob
(clockwise) until it is securely tightened.
To lower the saw blade, loosen the handwheel lock
knob (counterclockwise) and turn the handwheel
counterclockwise. When the saw blade is at its desired
height, tighten the handwheel lock knob (clockwise) until
it is securely tightened. SEE FIG. 28

TILTING THE BLADE

The blade bevel handwheel and handwheel lock knob
are located on the right side of the cabinet. To increase
the saw blade bevel, loosen the adjustment knob (C) and
then turn the hand wheel clockwise. When the saw blade
is at its desired degree, tighten the adjustment knob
(clockwise) (C). SEE FIG. 28A
Fig. 28A

ADJUSTMENTS

A
C
ADJUSTING BLADE BEVEL
POSITIVE STOP
Fig. 29
B
1. To adjust blade to a 90-degree blade bevel positive
stop, raise the saw blade (A) to its highest position.
SEE FIG. 29
2. Using a combination square (B) check that the blade
is 90 degrees to the saw table (zero degrees on bevel
Scale).
3. If the blade will not tilt to 90 degrees, when the set
screw contacts the stop position, and turn it until
the blade can be positioned to 90 degrees.
4. Once the blade has been tilted to 90 degrees (confirm
this using your square), tighten the adjustment
handle, located on the front of the cabinet. This will
keep the blade from tilting further. SEE FIG. 28
5. If the blade will not tilt to 45 degrees, when the set
screw (D) contacts the stop position and turn it until
the blade can be positioned to 45 degrees.
SEE FIG. 30
Fig. 30
C
24
A
D