Fig. 7
Fig. 8
Fig. 9
C
B
35990CS&35990SS EXTENSION WING
ASSEMBLY PROCEDURES
WARNING
!
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
1.
The extension wings are heavy; two people are
required to assemble both extension wings to the
table saw.
Fig. 10
2
One person put right/left extension wing on the top of
cabinet. And align the three mounting hole of wing to
the hole of table, Another person use M8x16mm hex
soc head screw (A) with M8 lock washer and M8 flat
.
washer to secure it, do not tighten them completely.
SEE FIG.10
4.
Using two 5/16-18x28mm hex soc head screw
(B)with M8 lock washer and M8 flat washer through
the hole of the bottom of cabinet and tighten them.
SEE FIG.11
Fig. 11
NOTE: To adjustment for this unit, please refer to the
page 18-19 of extension wing assembly.
19
A
B