Steel City 20-400 Owner's Manual page 11

The bottom of the guide should not rub on the cast iron
table. Three points consisting of the two ball bearings
and the plastic cylinder must be the only points of
support. A slight gap with the underside of the guide is
desirable. The brackets attached to the cast iron table
allow this adjustment.
8. Adjust the height of the two profiles so that the guide
slides from left to right keeping a gap with the table.
Finally tighten the 4 screws fixing the 4 brackets.
Plastic Cylinder
The graduated tape must be glued to the upper groove
of the «d» profile. The profile can be moved to the right
or to the left, it is advisable to work with the saw to see
the most frequent position of the profile.
9. This being done, press the guide against the blade and
stick the ribbon in the groove, the zero of the ribbon
aligned with the cursor of the indicator
◊ BLAde inserT
Place the blade insert into the recess in the cast iron
table.
A gap between the
table and the guide
Page 11
◊ sTorAge
Unscrew the 4 screws on the frame and attach the hook
and the box.
◊ riP CoLuMn
1. Lightly screw 2 nuts with 2 small screws.
2. Insert the assembled bolts at 1 on each side of the rip
column.
3. Slide the nuts at the end of the guide into its lateral
groove.
4. Lock in the desired location by tightening the handles.