Steel City 20-400 Owner's Manual page 14

◊ TABLe squAring
A hexagon bolt fitted with a counter nut is the stop for
quickly adjusting the table to 90 ° relative to the blade.
1. Disengage all ball bearings to eliminate interference.
2. Loosen the locknut of the stopper.
3. Loosen the rear compass lock handle.
4. Loosen the two handles located under the roundabouts
of the table.
5. Depending on the clearance between the blade and the
bracket, tighten or loosen the screw that serves as a
squareness stop.
6. When the squareness satisfies you, lock the height of
the stopper by tightening the lock nut.
◊ FrequenCY oF roTATion
2 rotation frequencies are possible. The choice of a
frequency is defined by the type of material.
Material harder, thicker = reduced rotation frequency.
Material softer, thinner = higher rotation frequency.
1. Eliminate belt tension: loosen the knob, raise the engine
and tighten the knob.
Controller
2. Rotate the belt and move it to transfer it into the proper
V-groove on both the drive pulley and the lower wheel.
575 RPM
3. Retension the belt and lock the engine with the handle.
Page 14
905 RPM