Section 11 Adjustments - Steel City 35619 User Manual

HANDWHEEL ASSEMBLY
Fig. 3
B
A
1. Line up the key on the shaft with the keyway in the
handwheel (A), and slide the handwheel onto the
shaft. SEE FIG. 3.
2. Tighten the set screw on the handwheel hub
securely to hold in place.
3. Install center lock knob (B) by inserting into center
hole in the shaft and threading in a clockwise
direction.
BLADE GUARD ASSEMBLY
1. Before installing the blade guard assembly, it is
recommended to make sure that the splitter bracket
is aligned properly.
2. To align the splitter bracket, line a straight edge up
against the face of the arbor flange (A) and the face
of the splitter bracket assembly (B). Please note
that when lining the straight edge against the
splitter bracket, make sure to put the straight edge
towards the top of the bracket so you are actually
lining the machined face of the splitter bracket with
the machined face of the arbor flange. SEE FIGS.
5A and 5B.
Fig. 5A
A
Fig. 5B
3. If an adjustment is necessary, loosen the two
socket head cap screws(C), and reposition the
bracket so that it is in line with the machined face
of the arbor flange. Retighten the screws once
alignment is achieved. SEE FIG. 5C.
Fig. 5C
4. Once the bracket is aligned, it is also necessary to
make sure it is square with the table. Check the
squareness of the bracket as shown in Fig. 5 D.
SEE FIG. 5D.
Fig. 5D
B
18
C