Setting Up The Transmitter; Display - GE HygroTrace User Manual

Setting Up the Transmitter

After proper installation, the HygroTrace Transmitter can be set
up to accommodate the user's requirements. Typically, the user
may need to configure the analog outputs, trim the analog
outputs, and program the digital outputs. Refer to the Menu Map,
Figure 9 on page 23, and complete the following steps. Upon
startup, the HygroTrace proceeds through several displays until a
screen similar to the following appears:
Note: In most instances; use the Enter key to save an entry and/
or move ahead to the following screen; use the Cancel key
to reject an entry and/or return to the previous screen.

Display

Diagnostics
- has limited access. The service passcode is
required. For a description, see Diagnostics on page 29.
HygroTrace Moisture Transmitter
The symbol in the lower right corner
indicates that the screen is locked.
To unlock the screen, press
Cancel, Enter, Cancel.
When the screen is unlocked, the
Main Menu appears with several
options. To set up the display, select
Display... and press Enter. The
following screen appears:
To show the primary ppb
select Measurement and press
Enter. A screen similar to the
following appears:
Press Cancel to return to the Main
Menu.
September 2007
display,
v
13