Cd-Rom Drive - Fujitsu 420D User Manual

To Install or Remove a Device
in the Multi-function Bay
1. Put your notebook into Suspend Mode.
To Remove
2. Slide the release latch on the right side
toward the bottom of your notebook.
3. Slide the module forward until the unit is
clear of the chamber.
To Install
2.Orient the item to be installed with the finger
ridge away from the body of your notebook
and the connector toward the body of your
notebook.
3. With the module connector toward the back
of your notebook align the grooves on the
side of the device with the tracks in the side
of the bay. (Figure 4-9.)
4. Slide the module toward the back of your
notebook until it clicks into place.
U s e r I n s t a l l a b l e
C A U T I O N
Be careful aligning and seating modules
in the bay. If the fit is incorrect you may
damage the bay or the module. If the
module does not move easily, remove
it, and check for dirt or foreign objects.
It will require a firm push to latch the
module in place.

CD-ROM Drive

The removable,modular CD-ROM drive is
durable, however, you must treat it with care.
Please pay attention to the following points:
The drive rotates the compact disk at very
high speed. Do not carry it around or subject
it to shock or vibration with the power on.
Avoid using or storing the drive or CDs wh ere
t h ey wi ll be ex po s ed to ex treme tem pera tu re s .
Avoid using or storing the drive or CDs
where it is damp or dust y.
L i f e B o o k 4 0 0 S e r i e s f r o m F u j i t s u
F e a t u r e s
Avoid using or storing the drive near magnets
or devices that generate strong magnetic
fields.
Avoid storing the drive where it will be sub-
jected to shock or vibration.
Do not disassem ble or dismantle the
C D - ROM drive .
Loading a CD
Make sure that the tilt adjustment feet on the
bottom of the notebook are folded flat
against the bottom of your notebook.
Make sure there is power to your notebook.
Push and rel e a s e , gen t ly but firm ly, on the
ej ect but ton on the front of the CD-RO M
d rive to open the drive . The tray wi ll come out
a short distance . (See Fi g u re 2-14 on pa ge 34. )
Gently pull the tray out until a CD-ROM can
be easily placed in the tray.
Ma ke su re that the pro tective sheet that was in
the tray wh en it was shipped has been rem oved .
85