Fujitsu 420D User Manual page 63

Table 3-2 Options and Defaults for the IDE Adapter Submenu
Parameter Options
*Sectors/Track: A number between
0 and 63.
*Write Precomp: None or a four
digit number.
*Multi-Sector Disabled; 2;4; 6; 8; 16.
Transfers:
*LBA Mode Control: Enabled; Disabled.
C o n f i g u r i n g Y o u r L i f e B o o k 4 0 0 S e r i e s
Default
When one of the preset combinations
is selected the value set is displayed but
cannot be changed from the screen. This
field can only be changed from the screen
when Type: is selected as User.
When one of the preset combinations
is selected the value set is displayed but
cannot be changed from the screen. This
field can only be changed from the screen
when Type: is selected as User.
When one of the preset combinations
is selected the value set is displayed but
cannot be changed from the screen.Only
when Type selected is User can
this field be set from the screen.
When one of the preset combinations
is selected the value set is displayed but
cannot be changed from the screen. This
field can only be changed from the screen
when Type: is selected as User.
L i f e B o o k 4 0 0 S e r i e s f r o m F u j i t s u
Description
Sets the number of sectors on the hard disk. This field
can be changed by incrementing or by typing in the
number followed by the Enter key.
Sets the amount of write compression to be used
in storing data on the hard disk. This field can be
changed by incrementing or by typing in the number
followed by the Enter key.
Sets the number of sectors allowed in a block transfer.
Enables or disables Block Addressingin place of
Cylinder, Head, Sector addressing.
55