Fujitsu 420D User Manual page 127

Problem
Error Messages are displayed when the CD-
ROM drive is not installed. Messages are:
* CD-ROM Drive not ready, aborting
i n s t a l l a t i o n
* Device driver not found:
` O E M C D 0 0 1 '
* No valid CDROM device drivers
s e l e c t e d
Notebook fails to recognize CD-ROM.
T r o u b l e s h o o t i n g
Possible Cause
1. There are 3 messages that may be displa yed
during the boot sequence for your notebook
when there is no CD-ROM drive in the Multi-
function Bay. When you are using Windows
95 these messages flash by quickly and the
Windows 95 system loads. For a boot into
the MS-DOS operating system the messages
will stay on the screen when the C : \ >
prompt appears.
1. Shipping card is still in the CD-ROM
drive tray.
2. CD-ROM is installed with label face down.
3. CD-ROM is not pushed down onto raised
center circle of drive.
4. CD-ROM tray is not latched shut.
5. Setup Utility is set to something other than
CD-ROM.
L i f e B o o k 4 0 0 S e r i e s f r o m F u j i t s u
Possible Solution
1. These messages are normal and do not indi-
cate a problem with your system. The software
to operate a CD-ROM drive is installed and the
system looks for one on a regular basis so that it
will recognize it as soon as it is installed with-
out having to reboot the system.
1. Remove shipping card and replace CD
in tray.
2. Open CD-ROM tray and re-install CD with
proper orientation.
3. Open CD-ROM tray and re-install CD
properly.
4. Push on the front of the CD-ROM tray until
it latches.
5. Revise BIOS settings to set IDE Adapter 0
correctly. (See Main Menu and IDE Adapter 0
Submenu pages 52-56 for more information.)
107