Problem: Can't Access Through Telnet; Problem: Can't Access Web Configurator - E-data DSL-2120 Series User Manual

STEPS
1 Check the telephone wire and connections between the DSL-2120/2120W DSL port and
the wall jack.
2 Make sure that the telephone company has checked your phone line and set it up for
DSL service.
3 Reset your ADSL line to reinitialize your link to the DSLAM.
4 If the problem persists, contact your local distributor for assistance.
A.2 Problem: Can't Access Through Telnet
I cannot telnet into the DSL-2120/2120W.
STEPS
1 Check the LAN port and the other Ethernet connections.
2 Make sure you are using the correct IP address of the DSL-2120/2120W. Check the IP
address of the DSL-2120/2120W.
3 Ping the DSL-2120/2120W from your computer.
If you cannot ping the DSL-2120/2120W, check the IP addresses of the
DSL-2120/2120W and your computer. Make sure your computer is set to get a dynamic
IP address; or if you want to use a static IP address on your computer, make sure that it
is on the same subnet as the DSL-2120/2120W.
4 Make sure you entered the correct password. The default password is "1234".
If you forgot your username or password, refer to Section A.4.
5 If the problem persists, contact the distributor.
A.3 Problem: Can't Access Web Configurator
I cannot access the Web configurator.
STEPS
1 Make sure you are using the correct IP address of the DSL-2120/2120W. Check the IP
address of the DSL-2120/2120W.
2 Make sure that a console session isn't running.
3 Check that you have enabled Web service access. If you have configured a secured
client IP address, your computer's IP address must match it. Refer to the chapter on
remote management for details.
4 For WAN access, you must configure remote management to allow server access from
the WAN (or all).
Proprietary & Confidential
Revision: V1.0
CORRECTIVE ACTION
CORRECTIVE ACTION
CORRECTIVE ACTION
Page 72 of 86
Apr. 23, 2008