Wep; Wpa-Psk - E-data DSL-2120 Series User Manual

LABEL
Active
Action
MAC Address

4.4.3.1 WEP

Key 1 to Key 4: Enter the key to encrypt wireless data. To allow encrypted data transmission,
the WEP Encryption Key values on all wireless stations must be the same as the router. There
are four keys for your selection. The input format is in HEX style, 5 and 13 HEX codes are
required for 64-bitWEP and 128-bitWEP respectively.
If you chose WEP 64-bits, then enter any 5 ASCII characters or 10 hexadecimal characters
("0-9", "a,b,c,d,e,f").
If you chose WEP 128-bits, then enter 13 ASCII characters or 26 hexadecimal characters
("0-9", "a,b,c,d,e,f"). You must configure all four keys, but only one key can be activated at any
one time. The default key is key 1.

4.4.3.2 WPA-PSK

Encryption: TKIP (Temporal Key Integrity Protocol) utilizes a stronger encryption method and
Proprietary & Confidential
Revision: V1.0
Select Actived to enable MAC address filtering.
Define the filter action for the list of MAC addresses in the MAC address
filter table. Select Deny Association to block access to the router, MAC
addresses not listed will be allowed to access the router. Select Allow
Association to permit access to the router, MAC addresses not listed will
be denied access to the router.
Enter the MAC addresses (in XX:XX:XX:XX:XX:XX format) of the wireless
station that are allowed or denied access to the router in these address
fields.
Page 33 of 86
DESCRIPTION
Apr. 23, 2008