The Firmware Screen - E-data DSL-2120 Series User Manual

Daylight Saving
NTP Server Address
A Network Time Protocol (NTP) server can automatically set the DSL-2120/2120W's time
for you. If you use an NTP server, you will only need to select your time zone. If you manually
set the time, you can enable Daylight Saving. The DSL-2120/2120W will automatically adjust
when Daylight Saving goes into effect.
When you are done making changes, click on SAVE to save your changes or on
CANCEL to exit without saving.

7.3 The Firmware Screen

Use the Firmware screen to view and update your DSL-2120/2120W's firmware. The
Firmware screen provides a different way to update the firmware than those given in Chapter
2.
The following table describes the labels in this screen.
LABEL
Current Firmware Ver
New Firmware Location
New Romfile Location
Romfile Backup
Once you have entered the new firmware's location in the field, click on UPGRADE to
upload it to your DSL-2120/2120W. Note that upgrading might take several minutes. Do not
turn off your DSL-2120/2120W during this time. It will restart automatically after upgrading
finishes.
Proprietary & Confidential
Revision: V1.0
Daylight saving can be toggled Enabled or Disabled.
Enter the NTP server address you wish to use here.
The current firmware version your DSL-2120/2120W is using.
The location on your computer of the firmware you wish to upload.
Enter the location here, or click on Browse... to find it.
The location on your computer of the Romfile you wish to upload. Enter
the location here, or click on Browse... to find it.
Click on "ROMFILE SAVE" to save Romfile on your computer
Page 65 of 86
DESCRIPTION
Apr. 23, 2008