Table of Contents
Advertisement
Encapsulation
Bridge interface
Connection
TCP MSS Option
Get IP Address
Static IP Address
IP Subnet Mask
Gateway
NAT
Default Route
TCP MTU Option
Dynamic Route
Multicast
Your ISP should provide the above information. Note that you must enter the user name
exactly as your ISP assigned it. If the assigned name is in the form of user@domain where
domain identifies a service name, enter it exactly as given.
4.2.2.4 Bridge Mode
The following table describes the labels in this screen.
LABEL
Encapsulation
4.3 The LAN Screen
The LAN screen allows you to set up how your DSL-2120/2120W connects to your LAN.
When you are done making changes, click on SAVE to save your changes or CANCEL to reset
the fields to their original states.
Proprietary & Confidential
Revision: V1.0
Select your encapsulation type from the dropdown list.
Select whether Bridge interface is activated or deactivated.
Select whether your connection is always on or if it connects on
demand. If on demand, specify how many minutes the connection may
be idle before it disconnects.
Enter the TCP MSS you wish to use here.
Choose whether the TC3162 EVM obtains the IP address statically or
dynamically.
Enter the static IP address here. Only if you chose Static above.
Enter the IP subnet mask here. Only if you chose Static above.
Enter the gateway here. Only if you chose Static above.
Select whether NAT is Enabled or Disabled.
Select whether this PVC will be the default route for Internet data.
Enter you TCP MTU bytes here. (Default is 0 bytes)
Select the RIP type and direction from the dropdown lists.
Select the multicast protocol you wish to use from the dropdown list.
Select your encapsulation type from the dropdown list.
Page 26 of 86
DESCRIPTION
Apr. 23, 2008
Advertisement
Table of Contents
