Microsd Card Installation Guide; Default Username And Password - Amcrest IP8M-2496E User Manual

3.3 MicroSD Card Installation Guide

To Install a microSD card into your camera, please refer to the step by step guide below:
Note: You will need a basic Phillips head screwdriver to complete the installation.
1. Locate and remove the protective plate located on the bottom portion of the camera. This plate can be found right
above the serial number sticker of the unit.
2. Remove the protective plate with a Phillips head screwdriver and locate the microSD card slot for the camera. It is
located right above the factory reset switch.
3. Insert the microSD card into the slot, gold pins down and press into place to lock the micro SD card in the slot.
4. Once the microSD card is properly inserted, close the protective plate securely to complete the installation.
4 Camera Access Setup
This section of the guide will provide the user with information on how to setup access to the camera through any
of the following methods.

4.1 Default Username and Password

To login to the system for the first time, use one of the following default username/password combinations. Once
you've successfully logged in, it is highly recommended to change the password for security reasons.
Username: admin
Password: admin
Note: Logging in for the first time will prompt the user to change the password to the admin account.
10