Microsd Card Installation Guide; Camera Access Setup - Amcrest IP2M-854E User Manual

2mp ultrahd poe bullet camera

Table of Contents

8. Adjust the device to the desired position.

Using a Philip's head screwdriver, (not included) tighten the adjusting screw near the base of the camera

to lock the camera in position. Note: The process for mounting the eyeball camera is similar, but some of the

steps may vary.

3.3 MicroSD Card Installation Guide

To Install a microSD card into your camera, please refer to the step by step guide below:

Note: You will need to access the camera's motherboard to insert the microSD card.

1. Remove the cover located on the back of the camera with a Phillips head screw drive to access the

motherboard.

2. Locate the provided microSD card slot on the motherboard and insert the microSD card into the slot, (Gold

pins down).

3. Push the microSD card into the slot and release, the microSD card will then be locked into place and your

microSD card is now properly inserted into your camera.

4. To release the microSD card, press the microSD card in and release, the microSD card will then be released

from its locking clasp.

This section of the guide will provide the user with information on how to setup access to the camera through any

of the following methods.

Table of Contents

Do you have a question about the IP2M-854E and is the answer not in the manual?