How To Make A Firmware Update For Hp 8114A; Supported Hardware; Procedure - HP 8114A Service Manual

How to Make a Firmware Update for HP 8114A

Supported Hardware

Procedure

Installing the HP 6114A
HP 8114A serial number 3330Gxxxxx and higher
2. Put the Memory Card in the slot at the right-hand side of the
front panel with the arrow on the card at the same side as the
arrow on the front panel (the card will not fit if inserted the
wrong way round)
4. While holding both keys down, switch HP 8114A ON
5. When
on
appears the display in very large letters, release the
6. After some seconds the message:
HP8114 Boot Program...
appears
7.
If you get the message:
Firmware is not newer
then an update is unnecessary: Press the MD softkey
8. You may get a message like:
There is 1 board unknown. Load anyway.
Press the YES softkey.
The EPROMs are now erased and re-loaded:
The first EPROMS will now be erased and this message is
n
displayed:
Erase U6 and Ui'; please wait.
After one or two minutes you will hear a short beep and the
n
next EPROMs will be erased:
Erase U8 and U9; please wait.
After another one or two minutes, you will hear a short beep
n
and the final EPROMs will be erased:
Erase U41 and U42; please wait.
beep
Program all Flash Eproms; please wait.
After the final beep you get the message:
n
Loading Finished
the following message is displayed:
keys