Removing The Output Board Fan; Refitting The Output Board Fan - HP 8114A Service Manual

Removing the Output Board Fan

Refitting the Output Board F'an
T I M I N G
Figure 4-13. Location of the Output Board
1. Follow the instructions for Removing the Instrument Cover,
2. Remove the 1 screw securing the fan and its holder to the chassis.
See Figure 4-13.
cable
3. Disconnect the fan
4. Push the fan a little bit towards the front panel at the timing board
side, and pull it out of the guides in the chassis.
Refitting the output board fan is the reverse procedure of removal.
HP 8114A Service Guide
5102 on the output board.
Disassembly and Reassembly 4-17
Fan