Operating Environment - HP 8114A Service Manual

8114A
BP Service Guide
Warning

Operating Environment

Warning
1-4 Installing the HP g114A
This instrument contains a lithium battery. The battery is not
user-replacable and replacement should only be carried out by
qualified service personnel.
There is a danger of explosion if the battery is incorrectly
replaced.
The battery must be replaced with the same or equivalent type
(HP Part No. 1420-0394). Discard used batteries according to local
regulations.
the HP 8114A to rain or other excessive moisture. Protect the
cause condensation within the instrument.
' Do not operate the HP 8114A in the presence of flammable
n
gases, fumes or powders. Operation of any electrical
instrument in such an environment constitutes a definite safety
hazard.
.
A
When working with output voltages of 30 - 1OOV
amplitude, the output voltage can be dangerous to life. Care
should therefore be taken when connecting the HP 8114A
external devices.
.
A
When working in
the external load the output voltage can be higher than the
programmed voltage. V,, can be as much as 130 V, even when
set as low as 2 V,,.
(High-Z) mode, if you remove
to