Raven Hawkeye 2 Installation Manual page 41

4. Locate the RCM - Sprayer power cable (P/N 115-2005-025) provided in the kit.
5. Connect the 12-pin Deutsch connector (gray) of the power cable to the remaining 12-pin Deutsch connector
(also gray) of the RCM - Sprayer cable.
NOTE: Secure the RCM - Sprayer cable to nearby existing cables with zip ties, ensuring not to pull on any
connections and prevent any cable loops from drooping below chassis.
6. Route the power cable forward along the chassis frame beneath the cab to the right lift arm, following the
existing cabling along the lift arm to the back of the center rack.
7. Connect the large, round female receptacle to the mating connector on the power cable of the sprayer.
NOTE: The remaining large, round male connector will be connected in a later step.
8. Locate the RCM - Sprayer left/right cable (P/N 115-2005-026).
9. Locate the bulkhead connector hole on the back side of the center section near the right lift arm.
10. From the front side of the spray boom, insert the round female bulkhead receptacle of the left/right cable into
the mounting hole. Use the provided washer and nut to secure the receptacle to the center section.
FIGURE 6. Bulkhead Connection Location
11. Connect the round male bulkhead connector of the power cable to the receptacle of the left/right cable.
RCM - Sprayer Mounting and Connection: RCM - Sprayer Installation
RCM - SPRAYER MOUNTING AND CONNECTION
Mounting Hole
37