Raven Hawkeye 2 Installation Manual page 47

For new holland/miller my 2018 small frame and my 2019+ all frames

Hide thumbs Also See for Hawkeye 2:

Table of Contents

6. Dry out the connection with dry, compressed air. Dust Off Electronics Duster (P/N 222-4001-007) is

recommended however, if unavailable, alternate compressed air sources can be used. If using compressed air

from a large volume air compressor, be sure the lines are free of moisture.

7. If not already applied, apply a single short burst of corrosion inhibitor (Corrosion X HD (Raven P/N 222-0000-

020 or available from http://www.corrosionx.com/corrosionx-heavy-duty.html)) into the NCV connection. Be

sure the corrosion inhibitor has coated the NCV contacts and recessed portions of the connector.

NOTE:

To determine is corrosion inhibitor has been applied, inspect for a thick liquid in the bottom of the

connector (as shown in the Corrosion Inhibitor Applied image below).

Applying Corrosion Inhibitor

Cable and Connector Maintenance: Hawkeye® 2 Boom Harness Connector Maintenance

CABLE AND CONNECTOR MAINTENANCE

Corrosion Inhibitor Applied

Table of Contents