3. Insert and hand tighten the remaining flathead screws, starting with hole number 1.
4. Tighten all flathead screws with a hex key to secure the mounting bracket to the cab.
5. Insert all three bolts through the washers into their respective RCM - Sprayer mounting bosses.
NOTE:
Observe the different length of the M6 hex bolts and their respective ECU mounting bosses.
6. Position the RCM - Sprayer on the mounting bracket and hand tighten the top bolt to secure the RCM -
Sprayer.
7. Hand tighten the remaining bolts and secure the RCM - Sprayer by tightening all three bolts with a hex key.
FIGURE 4. RCM - Sprayer Mounted
RCM - Sprayer Mounting and Connection: RCM - Sprayer Installation
RCM - SPRAYER MOUNTING AND CONNECTION
35