Panasonic PN28240i-ID Operation Manual page 72

Available commands are listed below.
C Enable/disable the trap sending at a coldstart.
Press "C." The command prompt changes to " Enable or Disable coldstart trap
(E/D)>." Press "E" to enable the trap sending. Press "D" to disable it.
A Enable/disable the trap sending at an SNMP authentication failure.
Press "A." The command prompt changes to "Enable or Disable SNMP
Authentication trap (E/D)>." Press "E" to enable the trap sending. Press "D" to
disable it.
L Enable/disable the trap sending at a login failure.
Press "L." The command prompt changes to "Enable or Disable Login failure trap
(E/D)>." Press "E" to enable the trap sending. Press "D" to disable it.
P Add a port to which the trap is sent when its link status changes.
Press "P." The command prompt changes to "Enter port number>." Enter a port
number. The trap is sent for this port.
D Delete a port to which the trap is sent when its link status changes.
Press "D." The command prompt changes to "Enter port number>." Enter a port
number. The trap is not sent for this port.
Q Return to the previous menu.
Note: There is no individual configuration item for loop detection trap. They
are sent based on the SNMP Trap Receiver Configuration.
72