Panasonic PN28240i-ID Operation Manual page 128

Screen Description
Monitoring Port Shows the destination port number of data to be monitored.
Be Monitored Shows the target port number to be monitored.
Port(s)
Direction Shows the communication direction of target packet to be
monitored.
Tx
Rx
Both
Status Shows the status of port monitoring.
Enabled
Disabled
Available commands are listed below.
S Set a destination port of data to be monitored (port to which analyzer, etc. is
connected).
Press "S." The command prompt changes to "Enter port number>." Enter a target
port number.
M Set a port to be monitored.
Press "M." The command prompt changes to "Enter port number>." Enter a target
port number.
When entering multiple port numbers, delimit with comma with no space, or
hyphenate the continuous numbers.
D Set a communication direction of target packet to be monitored.
Press "D." The command prompt changes to "Select port monitoring direction
(R/T/B)>." Enter "R" to monitor a receive packet. Enter "T" to monitor a transmit
packet. Enter "B" to monitor both receive and transmit packets.
C Set the status of port monitoring.
Press "C." The command prompt changes to "Enter the select(E/D)>." Enter "E" to
start monitoring. Enter "D" to stop monitoring.
Q Return to the previous menu.
Monitors a transmit packet.
Monitors a receive packet.
Monitors both transmit and receive packets. (Factory
default setting)
Port monitoring is enabled.
Port monitoring is disabled. (Factory default setting)
128