Maintenance And Storage; Garment Cleaning/Disinfecting Instructions - Bio Compression Systems SC-3004-DL Operating Instructions Manual

7. HOUR METER
7.1 The hour meter is displayed for 5 seconds each time you turn on your pump. The
numbers in the "LED Readout" show the 1-999 hours, the letter in the "Chamber
Number LED" indicates the following:
A. Less than 1000 hours
B.= 1000 - 2000 hours
C.= 2000 - 3000 hours
D. = 3000 - 4000 hours
E. = 4000 - 5000 hours
F.= 5000 - 6000 hours
7.2 To RESET the internal hour meter and return the pump to factory settings, with
the pump turned off, press and hold the "Mode", "Up" and "Down" buttons all
at the same time for 5 seconds. The LED will then Light up.
7.3 After 5 seconds, release the three buttons and press the "MODE" button. This
will reset the internal hour meter and return the pump to the original factory
settings.
IMPORTANT USAGE INFORMATION:
This pump has a customized software that remembers the pressure require-
ments of each and every patient. It is very important to reset the pump back
to the original factory settings prior the placing the pump on a new patient.

MAINTENANCE AND STORAGE:

EXTERIOR PUMP CASING CLEANING INSTRUCTIONS:
1. Clean the exterior case and tubing with a damp (not wet) cloth using mild soap
and water solution once per month or as needed.
WARNING!
 Only an authorized technician may open the pump
Before cleaning, unplug power cord from electrical outlet


GARMENT CLEANING/DISINFECTING INSTRUCTIONS:

Disconnect garment from device
2. Open garment to expose all sides either by separating Velcro type hook and loop
or by unzipping (depending on type of garment).
WARNING!
 Do not allow liquids to enter the pump, as this can present an electrical
hazard
Always allow the pump to dry before using

Do not use bleach on the pump

12