Usage; Operation; Taking An X-Ray Image - Air Techniques SensorX Installation And Operating Instructions Manual

Usage

EN-
Usage
US
9

Operation

CAUTION
If the sensor is damaged, harmful
substances may exit from the unit
Check the sensor and cable for dam-
❯
age before every use.
Do not use the sensor if it is damaged.
❯
Use a right-angle holder.
❯
NOTICE
Damage to the sensor
The interior parts of the sensor can be
damaged by mechanical forces.
Do not drop the sensor.
❯
Do not subject the sensor to any pres-
❯
sure.
Do not fold, clamp or crush the cable.
❯
Do not carry the sensor by the cable.
❯
We highly recommend using the sensor with a
right-angle holder. This prevents positioning
errors and protects the sensor against mechani-
cal damage (e.g. through an alarmed patient bit-
ing the sensor).
Operating the sensor with DBSWIN or via
VistaEasy, you can generate X-ray images in two
acquisition modes:
– Standard (26.3 LP/mm)
– Low resolution (13.15 LP/mm)
The transmission time is just a few seconds
depending on sensor size and settings.
24
9.1

Taking an X-ray image

Check before every use:
ü The sensor and cable are not damaged.
ü The sensor and cable have been cleaned and
disinfected.
Wear hand protection.
Start the computer.
❯
Start the imaging software.
❯
Select the desired image mode.
❯
Make SensorX ready for image acquisition in
❯
the imaging software.
WARNING
Danger of cross contamination when
not using the hygienic protective
cover or when using the hygienic pro-
tective cover more than once
The materials used for the hygienic pro-
tective cover are not suitable for reproc-
essing. This can result in malfunctions,
leaks and material failure.
Do not use the unit without the
❯
hygienic protective cover.
Do not re-use the hygienic protective
❯
cover (disposable item).
Push the hygienic protective cover (see "3.2
❯
Accessories") over the sensor.
2121100020L29 2101V007