Table of Contents
Advertisement
Installation
EN-
When connecting the unit to other devices,
❯
e. g. a PC system, comply with the require-
US
ments set out in section 16 of IEC 60601-1
(EN 60601-1).
When setting up the PC system in the vicinity
❯
of the patient:
Only connect components (e.g. computer,
monitor, printer) that comply with the standard
IEC 60601‑1 (EN 60601‑1).
When setting up the PC system outside of the
❯
vicinity of the patient:
Connect components (e.g. computer, monitor,
printer) that comply at least with the
IEC 60950‑1 (EN 60950‑1) standard.
Connecting the device to a computer
NOTICE
Damage to the sensor
The interior parts of the sensor can be
damaged by mechanical forces.
Do not drop the sensor.
❯
Do not subject the sensor to any pres-
❯
sure.
Do not fold, clamp or crush the cable.
❯
Do not carry the sensor by the cable.
❯
Connect the USB plug of the sensor cable to a
❯
free port on the computer.
If necessary, extend the cable by 1 m using the
❯
enclosed USB extension cable.
Further extensions are not permitted.
The USB extension can also be used if
the device needs to be plugged in and
unplugged regularly and the USB port
on the computer is not easily accessi-
ble. This protects the USB connection
on the computer.
The unit has no main power switch.
Therefore, it is important that the USB
connection on the PC and, if necessary,
the socket outlet for the power supply,
are easily accessible and that the appli-
ance can be unplugged if necessary.
18
7.3
Installation with VisionX
Install the additional component
If the additional component of the unit was not
installed along with the installation of the imaging
software, it can be installed later on.
Place the data carrier of the imaging software
❯
in the drive or run the installation file.
The Start menu opens.
If the Start menu does not open automatically,
❯
run the file Start.exe.
Select the installation language you require.
❯
Accept the License Agreement.
❯
Select the required components.
❯
Select the SensorX unit.
❯
Follow the further instructions given by the
❯
installation wizard.
Installing the calibration data
Every sensor requires the individual cali-
bration data stored on the enclosed data
carrier.
Insert or plug the enclosed data carrier in the
❯
drive.
The data carrier starts automatically and the
calibration data are installed.
If the data carrier fails to start automatically, run
❯
the setup.exe file.
7.4
Installation with DBSWIN
Installing the driver(s)
Close all programs.
❯
Insert or plug the enclosed DBSWIN data car-
❯
rier in the drive.
The start window opens.
If the data carrier fails to start automatically, run
❯
the CD_Start.exe file.
Select the required language.
❯
2121100020L29 2101V007
Advertisement
Table of Contents
