Vecow ECX-2600 PEG User Manual page 125

BOOL get_GPIO1(WORD *GPIO_data)
Get GPIO.
GPIO_data ([15:0]) : GPIO state, pin setting by hexadecimal bitmask.
1 : High;
0 : Low.
Return :
TRUE (1) : Success.
FALSE (0) : Fail (Initial error or hardware problem).
BOOL get_WDT(DWORD *WDT)
Get watchdog timer setup.
WDT : watchdog timer setup.
Unit : second (Range : 0 ~ 65535 sec, 1093 ~ 65535 min (=65580 ~
3932100 sec)).
Return :
TRUE (1) : Success.
FALSE (0) : Fail (Initial error, or call by pointer error, or hardware problem).
BOOL set_WDT(DWORD WDT)
Set watchdog timer setup.
WDT : watchdog timer setup.
Unit : second (Range : 0 ~ 65535 sec, 1093 ~ 65535 min (=65580 ~
3932100 sec)).
Return :
TRUE (1) : Success.
FALSE (0) : Fail (Initial error, or setup 0, or hardware problem).
BOOL cancel_WDT()
Cancel watchdog timer.
Return :
TRUE (1) : Success.
FALSE (0) : Fail (Initial error or hardware problem).
BOOL initial_POE(BYTE Scan, BYTE ID)
Initial POE.
Scan : POEID scan type
2 : Auto scan; 1 : Manual setup.
ID : POE ID by manual setting.
Range : 0~15.
Return :
TRUE (1) : Success.
FALSE (0) : Fail (Driver not exists, or version is too old, or out of range error).
BOOL get_POE_configuration(BYTE ID, BYTE *Auto, BYTE *Mask)
Get POE configuration (by variable).
ID : POE ID.
Range : 0~15.
Auto ([3:0]) : Auto mode, pin setting by hexadecimal bitmask.
©Vecow ECX-2600/2400/2300 PEG User Manual Appendix B 117