Graphic Card Power Conn - Vecow ECX-2600 PEG User Manual

2.6.2 Ignition Control Wiring
To activate ignition control, you need to provide IGN signal via the 3-pin
pluggable terminal block locates in the back panel. Please find below the
general wiring configuration.
DC-IN
V+ V
Pin No.
1
2
3
For testing purpose, you can refer to the picture blow to simulate ignition signal
input controlled by a latching switch.
Note :
1. DC power source and IGN share the same ground.
2. ECX-2600/2400/2300 PEG supports 9V to 50V wide range DC power input
in ATX/AT mode. In Ignition mode, the input voltage such as the wide voltage
operating range of the system is 9V to 50V DC.
3. For proper ignition control, the power button setting should be "Power Down" mode.

2.7 Graphic Card Power CONN

©Vecow ECX-2600/2400/2300 PEG User Manual
Definition
Ignition
SW+
SW-
GETTING TO KNOW YOUR ECX-2600/2400/2300 PEG
In Windows for example,
you need to set "When I
press the power button" to
Shut down.
1
6
Pin No. Definition
1 +12V
2 GND
3 +12V
4 GND
5 +12V
6 GND
56