Table of Contents
Advertisement
Chapter 5
Configure the UEFI (BIOS) Settings
58
SATA Configuration (for computers with Windows 7, 8.1, or 10 operating systems)
(1)
Parameter
SATA Mode
SATA Port (0, 1, 2, 4)
Hot Plug
External SATA Port
(1) See
page 52
for an explanation of common buttons near the bottom of screen.
(2) Applies only to computers that ship with Windows Server operating systems. For computers that ship with two HDDs but no
operating system, the HDDs are in AHCI mode instead of RAID and each drive acts independently.
Rockwell Automation Publication 6177R-UM002F-EN-P - May 2018
Description
Select an operation mode for the onboard SATA controller.
Options: Disabled, IDE Mode, AHCI Mode (default), or RAID Mode
Indicates the SATA HDD connected to the SATA connector.
Enables or disables hot plug support for the SATA port.
Options: Enabled (default) or Disabled
IMPORTANT: Make sure all writes to HDD are complete before your remove the
HDD from the system to avoid risk of data corruption.
Enables or disables eSATA port.
Options: Enabled (default) or Disabled
(2)
Advertisement
Table of Contents
