Post-configuration
Required Tools
Follow these steps after you install or you remove a hardware component.
1. Verify that all components are installed according to instructions.
2. Make sure that no tools or loose parts are left inside the computer.
3. Reinstall any expansion boards, peripherals, chassis cross members, and
system cables that were previously removed.
4. Reinstall the cover according to the instructions on
5. Reconnect all external cables and power to the computer.
6. Press the power switch to start the computer.
The following tools are required for component replacement:
• #2 cross-head screwdriver
• anti-static wriststrap
• Side cutters (to cut cable ties, if necessary)
Rockwell Automation Publication 6177R-UM002F-EN-P - May 2018
Replace Components
Chapter 4
page
37.
35