Table of Contents
Advertisement
Set-up Utility Overview
Configure the UEFI (BIOS) Settings
Topic
The set-up utility is a hardware configuration program that is built into the
universal extensible firmware interface (UEFI). In this chapter, UEFI replaces
Basic Input/Output System (BIOS) to describe the system firmware except
where BIOS is used, such as on a graphical interface.
The UEFI is already configured and optimized so there is no need to run this
utility. However, you can run the set-up utility to do the following:
• Change the system configuration.
• Change the UEFI setup when the system detects a configuration error.
• Redefine communication ports to prevent any conflicts.
• Read the current amount of system memory.
• Change the boot drive order.
• Set or change the password, or make other changes to the security
settings.
• Upgrade the system firmware.
• Run the diagnostic utility to determine the cause of system malfunction.
• Restore or back up the operating system.
Rockwell Automation Publication 6177R-UM002F-EN-P - May 2018
5
Chapter
Page
49
50
50
51
52
71
73
80
49
Advertisement
Table of Contents
