Table of Contents
Advertisement
Chapter 4
Replace Components
48
12. Disconnect the two SATA cables from the HDD assembly.
IMPORTANT
13. Remove the PSU.
14. Install the new PSU in the reverse order of the removal steps.
a. Step 11: Torque the five screws to 1.4 N•m (12 lb•in) to secure the
new PSU.
b. Step 4: Reinstall the chassis cross member or I/O card retention
bracket as detailed in
c. Verify that all cables are properly connected before you reinstall the
cover.
d. Remove and replace any cut cable ties.
15. Follow the steps for
Rockwell Automation Publication 6177R-UM002F-EN-P - May 2018
Mark each SATA cable so that you can reconnect them to the correct
port after you install the new PSU.
Install I/O Card Retention Bracket on page
Post-configuration on page
90.
35.
Advertisement
Table of Contents
