Table of Contents
Advertisement
4. If necessary, remove any accessory
boards or cables that prevent access
to the RTC battery socket.
5. Remove the old battery.
a. Pull the battery cover straight
out of the battery socket.
b. Pull the old battery from its
socket.
6. Install the new battery.
a. Insert the new battery with the
positive polarity (+ side)
towards the SO-DIMM
memory slots.
Verify that the battery is seated
completely.
TIP
b. Reinstall the battery cover.
7. Follow the steps for
8. During POST, press F2 on an attached keyboard to access the UEFI setup
and reconfigure settings.
See
Chapter 5
for more information on UEFI settings.
IMPORTANT
This computer contains a sealed lithium battery that could need
replacement during the life of the computer.
At the end of its life, collect the battery that is contained in this
computer separately from any unsorted municipal waste.
Rockwell Automation Publication 6177R-UM002F-EN-P - May 2018
Remove old battery.
The socket retaining latches allow only one way for the battery to be
installed.
Post-configuration on page
If you replace the battery, then all UEFI settings return to their
default settings. UEFI settings other than default must be
reconfigured after you replace a battery.
Replace Components
Chapter 4
Battery Cover
RTC Battery
Socket
Retaining
Latches
Battery Socket
Install new battery.
35.
43
Advertisement
Table of Contents
