Table of Contents
Advertisement
3.3.1 Autonomous Intelligent Recharge
The robot has the function of intelligent autonomous recharge. The robot will return to the
charging pile to recharge if below two conditions are met. Besides, please ensure that the charging
pile is secured in position and plugged.
The battery power of the robot is lower than the recharge amount set by the user.
The robot is not disinfecting and its battery power has not reached 100%.
3.3.2 Adapter Charging
(Don't operating the robot while the adapter is charging.)
Please follow below steps to charge the robot through the adapter:
Power off the robot.
1
Open the silicone sleeve outside the charging jack in the back of the robot and use the
2
charging plug of the adapter to connect to the robot.
After successful connection, the adapter indicator will turn red (if the indicator light is
3
yellow, please press the indicator light, then the indicator light will turn red).
The charging is complete when the adapter indicator light turns yellow. Then, please
4
disconnect the adapter and plug the silicone sleeve outside the charging jack of the robot.
3.4 Filling Disinfectant
When the robot prompts that the disinfectant level is too low, the disinfectant needs to be
added manually. The filling port is located on the rear side of the body, as shown in Fig. 4. Please
lift up the silicone cover and pull out the inner gray silicone plug to add disinfectant.
10
Advertisement
Table of Contents
