Advertisement
At each marked location, drill hole using 25/64" drill bit and appropriate sized drill-bit stop
collar. If 25/64" drill bit is not available, a 3/8" drill bit can be used, although it may be
necessary to tap in the plus nuts.
Insert 1/4" x 2-1/4" hex head bolt through 1/4" flat
washer and plus nut installation tool, and then screw
bolt into plus nut. Knurled end of plus nut tool must
be directed away from bolt head and contacting plus
nut.
Insert plus nut into hole with plus nut tool attached.
Using the 9/16" box wrench, hold the plus nut tool
stationary and then tighten hex head bolt until plus nut is tightly gripping and does not spin
when hex bolt is loosened.
DO NOT overtighten plus nut.
Using the 9/16" box wrench, hold plus nut tool stationary to remove the 1/4" hex bolt.
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST)
Instructions – 40150
HOLD
Sample
installation
onto floor
shown.
Page 6
Advertisement
