Related Manuals for Kargo Master 4064P
Summary of Contents for Kargo Master 4064P
- Page 1 Installation Guide 4064P Kargo Master Rancho Cordova, CA 95742 800-343-7486 CustomerService@KargoMaster.com DATE: ______________...
-
Page 2: Table Of Contents
Install Instructions – 4064P *PLEASE READ ALL INSTRUCTIONS AND WARNINGS PRIOR TO ASSEMBLING, INSTALLING, AND USING THIS PRODUCT* Warning Always check for wires, fuel tanks and lines, brake lines and other important vehicle functionality items prior to drilling and installing all products. -
Page 3: Parts List
Install Instructions – 4064P Parts For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 2... -
Page 4: Hardware List
Install Instructions – 4064P Hardware For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 3... -
Page 5: Step 1 Install Top Wing
Install Instructions – 4064P Assemble Partition (40651) Step 1 – Install Top Wing • Use top wing (A) as a template. Hold top wing inside of van, above the seats and against the headliner. • Mark on the headliner through the slots of the top wing. -
Page 6: Step 2 Install Floor Mount
Install Instructions – 4064P Step 2 – Install Floor Mount • Remove D-Rings below seats. • Use bottom wing (B) as a template. Hold bottom wing inside of van below the seats. • Align the outside holes on the bottom wing with the previously removed D-Ring holes. -
Page 7: Step 3 Install Floor Supports
Install Instructions – 4064P Step 3 – Install Floor Supports • Place bottom supports (E, F & G) under bottom wing (B). • Align outside supports (E & F) with previously removed D-Rings. Bolt using ONLY the previously removed D-Rings. -
Page 8: Step 4 Install Wings
Install Instructions – 4064P Step 4 – Install Wings • Attach side wings (C & D) to both top and bottom wings (A & B) using two flanged hex head bolts (1) and two flanged nyloc nuts (2) in each corner. -
Page 9: Step 5 Install Partition
Install Instructions – 4064P Step 5 – Install Partition • Insert partition (40651 or 40652) assembly into van. Be sure to have the flanges to the rear of the van. • Bolt all around edges of partition to top and side panels using 1/4" flanged hex head bolts and 1/4"...