Advertisement
Step 1 – Bolt Drawer Units Together
Decide if two or three drawer units
will be stacked.
Stack two drawer units on top of
one another.
Place connector brackets so that
the holes from each drawer unit
align with the holes in each
bracket. Place the long end of the
bracket along the side of the
drawer unit and the short end at
the rear.
Screw the bracket into place using
#14 screws.
Tighten and repeat at all locations.
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST)
Instructions – 40150
Page 3
Advertisement
