Related Manuals for Kargo Master 4090L
Summary of Contents for Kargo Master 4090L
- Page 1 Instruction Guide 4090L Kargo Master Rancho Cordova, CA 95742 800-343-7486 CustomerService@KargoMaster.com DATE: ______________...
-
Page 2: Table Of Contents
Instructions – 4090L *PLEASE READ ALL INSTRUCTIONS AND WARNINGS PRIOR TO ASSEMBLING, INSTALLING, AND USING THIS PRODUCT* Warning Always check for wires, fuel tanks and lines, brake lines and other important vehicle functionality items prior to drilling and installing all products. -
Page 3: Parts List
Instructions – 4090L Parts For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 2... -
Page 4: Hardware
Instructions – 4090L Hardware 1 of 2 For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 3... - Page 5 Instructions – 4090L Hardware 2 of 2 For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 4...
-
Page 6: Step 1 - Load Plate
Instructions – 4090L Step 1 – Load Plate • Bolt load plate (D) to one end of each bow (A). • Use a 5/16” x 3/4" carriage bolt (1), 5/16” flat washer (4) and a 5/16” nyloc (7). • TIGHTEN. Skip if adding 40813. -
Page 7: Step 3 - Mount Side Tube
Instructions – 4090L Step 3 – Mount Side Tube • Place side tube (C) on top of installed bows. • The bend goes towards the front of the vehicle. Be sure to have orientation to your desire. • Leave one square slot open at the rear of the side tube. -
Page 8: Step 4 - Install Clamp Tube
Instructions – 4090L Step 4 – Install Clamp Tube • Place bushings (13) around clamp tube in orientation shown. • Insert clamp tube (F). • Slide hangar bracket (E) around tube. • Bolt hangar bracket into place using a 5/16” x 2” carriage bolt (3), a 5/16”... -
Page 9: Step 5 - Mount Latch Assembly
Instructions – 4090L Step 5 – Mount Latch Assembly • Bolt latch (G) at the rear of the mount tube (C) that was installed in Step 3 using a 5/16” x 2” carriage bolt (2), 5/16” curved washer (6) and a 5/16” nyloc (7). -
Page 10: Step 7 - Mount Ladder Stop
Instructions – 4090L Step 7 – Mount Ladder Stop to Bow • Bolt ladder stop (J) to the front bow in the orientation shown using a 3/8” x 1” carriage bolt (9), a 3/8” flat washer (11) and a 3/8” nyloc (12).