Advertisement
NO.S007 Pre-fab. Module Internal Combining Material Installation Position
Diagram-3
A
B
Install Armaflex
Install end wall
thermal insulation pipe
rock wool
Note:
1. Install the end module combination materials in the following sequence:
(1) Insert the Armaflex thermal insulation pipe.
(2) Use the end edge wrap to secure the rock wool,and apply glue to secure it at the position shown
in the figure.
(3) Install the thermal insulation foam in the edge wrap groove.
(4) Install the end at the module combination position on the end wall.
(5) Install the rock wool panel on the partition wall, as shown in the figure. Place the entire rock
wool panel from the front wall side, and install the front and rear flat buckles and internal corners.
(5) Install the internal corners, baseboards, and flat buckles as shown in the figure.
(6) After installing all internal sealing kits, ground the pre-fab. modules by referring to NO.S008
Pre-fab. Module Grounding Position Diagram.
A enlarged view
Edge wrap
Attach the end edge wrap to rock
wool using structural adhesive
B enlarged view
6. Internal corner
Rock wool 1
Install partition
Install baseboard, internal
wall rock wool
corner, and flat buckle
5. End thermal
7. Flat buckle
insulation foam
2. Edge wrap
1.Armaflex thermal insulation pipe
8. Baseboard1
3. Rock wool 1
Attach the end edge wrap to rock
wool using structural adhesive
End thermal insulation foam
Edge wrap
Armaflex thermal insulation pipe
4. Rock wool 2
Install the whole rock wool from this side.
9
DKBA61613971.ASM
DKBA61589565.ASM
8
7
DKBA04853355-A03R01_2950
6
DKBA04853355-A03R03_2950_KP5
5
DKBA82064398.ASM
DKBA04851489_F_3080X394X100
4
DKBA04851489_F_327X3079X25_C0
3
2
DKBA82064397.ASM
1
DKBA80998528.ASM
No.
Drawing No.
9. Baseboard 2
4. Rock wool 2
Baseboard2
Baseboard1
Flat buckle
Internal corner
End thermal insulation foam
Rock wool 2
Rock wool 1
Edge wrap
Armaflex thermal insulation pipe
Item
End internal sealing
2
1
3
2
3
1
2
3
8
Qty Remarks
Advertisement
