Advertisement
NO.S004 Pre-fab. Module Combining Position Diagram
1. Combination distance block
1. Combination distance block
2. Front distance block
Note:
1. Before combining pre-fab. modules, remove the transport side walls, and then install
combination distance blocks and front distance blocks.
2. Before combining pre-fab. modules, install combination distance blocks and front distance
blocks. After combining pre-fab. modules, remove the front distance blocks.
3. Each pre-fab. module combination position has four combination distance blocks.
4. Remove the transport side walls as follows:
1). Remove the edge wraps (marked 4 in the figure) from the side edge of the right panel
(marked 5 in the figure).
2). Remove the rightmost EPS panel (marked by 5 in the figure), and then remove the
remaining EPS panels in sequence according to the removal direction shown in the figure.
3). Remove the remaining edge wraps (marked 6 in the figure) of the transport side wall, and
then remove the remaining beams and columns (marked 7 in the figure) of the transport side
wall.
Remove the transport side wall (11 EPS panels) at the module combination position
2. Front distance block (1 PCS/module)
Screw assembly M10X40
1. Combination distance block (4 PCS/module)
Enlarged at 10:1
1. Side combination
distance block
GB9074_17-88_M10X40_S_ZNAL
3
Screw assembly M10X40
DKBA80912330 (300X150X25)
2
1
DKBA80897988 (200X50X25)
Combination distance block
No.
Drawing No.
Enlarged at 10:1
2. Front distance block
7
1
Front distance block
4
Qty
Item
Remarks
Advertisement
