Advertisement
FusionDC1000B Prefabricated Modular Data Center
Quick Guide (2020, Nigeria, Platform Capital
Refinery DC)
Step 2 Adjust the screw locations to change the height of the fixed arm.
Figure 2-4 Adjusting the fixed arm height
Step 3 Install the dampers.
1.
2.
3.
Issue 01 (2021-01-05)
NO TE
If there is no mounting hole in the cabinet bottom, you can also secure the posts to the
floor.
CA UTION
Before securing the door frame, assign two persons to hold the left and right
posts of the door frame to prevent the door frame from falling down and
hurting people or damaging equipment.
Rotate the rubber position in the damper, adjust the inner spacing of the
damper to 14 mm, and reduce the vertical distance between the damper and
the door to reduce the vibration of the glass door.
Secure the damper fastener to the aisle door post using M4x8 cross recessed
countersunk head screws.
Secure the damper and fastener using M4x8 cross recessed countersunk head
screws.
Copyright © Huawei Technologies Co., Ltd.
2 Installing an Aisle Door and an Access Control
Device Between Combined Pre-fab. Modules
6
Advertisement
