Lantech 2204F Series User Manual page 115

[Workport]
aggregator activityport
[Group ID]
[Port Numbers]
aggregator group
[GroupID] [Port-list]
nolacp
show aggregator
no aggregator lacp
[GroupID]
list, This parameter
could be a port
range(ex.1-4) or a port
list separate by a
comma(ex.2, 3, 6)
[Workport]: The
amount of work ports,
this value could not be
less than zero or be
large than the amount
of member ports.
G Set activity port
G
Assign a static trunk
group.
[GroupID] :1~3
[Port-list]:Member port
list, This parameter
could be a port
range(ex.1-4) or a port
list separate by a
comma(ex.2, 3, 6)
P
Show the information
of trunk group
G Disable the LACP
function of trunk group
108
or
switch(config)#aggregator group
2 1,4,3 lacp workp 3
switch>enable
switch#configure
switch(config)#aggregator
activityport 1 2
switch>enable
switch#configure
switch(config)#aggregator group
1 2-4 nolacp
or
switch(config)#aggregator group
1 3,1,2 nolacp
switch>enable
switch#show aggregator 1
or
switch#show aggregator 2
or
switch#show aggregator 3
switch>enable
switch#configure
switch(config)#no aggregator