Progress PBP5320 User Manual page 34

34 progress
6. Press
to start the procedure.
The bars on the symbol come on one
by one to show that the temperature in
the appliance increases. The symbol
flashes.
After some minutes the door locks. The
display shows the symbol
When the Pyrolysis is completed, the dis-
play shows the time of day. The oven door
stays locked. When the appliance is cool
again, an acoustic signal sounds and the
door unlocks.
To stop the Pyrolysis before it is com-
pleted, press
Removing the shelf supports
1
Installing the shelf supports
Install the shelf supports in the opposite se-
quence.
The rounded ends of the shelf supports
must point to the front.
Oven lamp
Warning! Be careful when you change
the oven lamp. There is a risk of
electrical shock.
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or de-
activate the circuit breaker.
.
.
2
Setting the end time for the Pyrolysis
You can use the End
lay the start of the procedure.
1. Start the Pyrolysis procedure.
2. Press
symbol
shows the time for the end of the
Pyrolysis.
3. Press + or - to adjust the time for
the end of the Pyrolysis.
Shelf supports
You can remove the shelf supports to clean
the side walls.
1. Pull the front of the shelf support away
from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove it.
Put a cloth on the bottom of the oven
to prevent damage to the oven light
and glass cover.
1. Turn the glass cover counterclockwise
to remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with an ap-
plicable 300 °C heat-resistant oven
light bulb.
Use the same oven lamp type.
4. Install the glass cover.
function to de-
again and again until the
flashes. The display