Siruba ASK-ASM100 Instruction Book / Parts List page 20

Speed limit of sewing
56 HL
machine head
Motor speed of
57 ACR
assistant trimming
Rotary stitches of
58 ACS
assistant trimming
59 CS Pedal sensitivity
Needle auto-rising
60 NUF
after power on
Safety switch of side
61 LSH
plate
Highest voltage record
62 HVR
display
Lowest voltage record
63 LVR
display
Present voltage record
64 PV
display
Time setting of auto
65 AOT
running test
66 AO1 Auto running start time
67 AO2 Auto running stop time
68 AOS Auto Running
Time display of auto
69 UTT
running
70 VER Software version
Functional automatic
71 GHT
operation
78 PS Password
The front sensor
79 FED rotation lock without
fabric
80 BKL LCD Backlight
81 LAN Language
Speed controller´s
82 FOO
voltage display
start / stop complex
83 UEG
switch
91 LDL Motor speed slope
P10
200~5500 3000 rpm
200-5000 3000 rpm
1-99 20 Stitch
1-10 2 level
ON/OFF ON //
ON/OFF OFF //
// // //
// // //
Realtime
// //
display
1~500 240 hr
1~20 2 s
1~20 2 s
ON/OFF OFF //
Instantaneous
1~1000 hr
display
ON/OFF OFF
// OFF //
ON/OFF OFF //
0%~100% 40% //
// English //
Instantaneous
0~4096 //
display
ON/OFF ON
165、200、
250、300、 200 ms
350
Speed limit ( first priority). After configure "56.HL＂
as 5500rpm, and the parameter "01.H＂ can be
configured as the highest speed.
Under VTE/CTE mode, after the sewing completes,
press Manual Trimming to activate "trimming and
assistant suction＂
IN OT/A mode, set 〝#59.CS〞to decide
the depth of pedaling as to initiate the motor.
The bigger the setting, the deeper you need to pedal.
ON: Enable the needle to rise automatically to the
highest position after power on. OFF: Disable
ON: Enable OFF: Disable
"62HVR＂ and "63LVR＂ can record the highest
and the lowest current effective value of the control
box AC.
Set time of auto running test
Set time to start the auto running
Set time to stop the auto running
ON: Enable the auto running test
OFF: Disable the auto running (Resume to OFF after
power off.)
Accumulate running time
The display controller firmware version is SXEX.
If press key then display UI firmware version
ON
OFF
* Parameters unable to make changes while the
motor is working.
When Password Lock is ON, all parameters cannot be
changed. The unlock password: 0168
Note: To go to the parameter setting, press S and
input the password, hold S till the monitor shows.
Under the OT/A mode, motor stops when the front
sensor detects no fabric.
English / Traditional Chinese / Simplified Chinese
OFF: Only starting function.
ON: Start and stop function.
Motor Acceleration / deceleration slope
165ms, 200ms, 250ms, 300ms, 350ms