Siruba ASK-ASM100 Instruction Book / Parts List page 19

24 TN1 Needle Location
25 BUZ Buzzer
Overlapping loose
26 LE
close stitch
27 ABC Long Suction
30 ATF Start mode selection
31 INF Laser light marker
32 TFD Solenoid Valve Check
Presser foot motion
33 TIN
stimulation
The initial full output
34 FT time of presser
electromagnet
35 FD Presser Foot Cycle %
Presser Foot
36 FPM
Protection
Presser Foot
37 FP
Protection Time
38 FMM Presser Foot Mode
Presser foot down
39 FMS
delay time.
half pedaling
40 HT
confirmation time
48 FMD Motor start delay time.
50 MSW Safety switch
The stop angle as the
53 SDA
needle descending
The stop angle as the
54 SUA
needle rising
55 ER Error code display
U/D/UD U //
ON/OFF ON //
200~6000 60
ON/OFF OFF
ON/OFF ON
ON/OFF ON
0~9 0 //
0、1、2、3 0~3
0~990 250 ms
10~50% 25 %
ON/OFF ON //
Solenoid:120
1~300
Second
E.Mag :30
ON/OFF ON //
1~3000 10 ms
0~990 100 ms
50~500 500 ms
ON/OFF OFF //
0-360 220 Angle DO NOT adjustment
0-360 30 Angle DO NOT adjustment
0~9 Set
U: The highest location D: The lowest location
UD: The lowest location, but presser foot rises when
fully pedal.
When presser foot protection On for 30 seconds (or
set time), the buzzer will beep twice.
Set stitch to run loose stitches after overlapping and
parameter 14.
Enable suction continuously during operation when
set ON.
ON: Pedal
OFF: Speed controller
ON
OFF
Each code refers to:
1. Presser Foot on (2 seconds).
2. All Off
3. Cut / Suction (50ms)
4. Stretching (2 seconds)
5. Cross Seam
6. Loose Stitch (2 seconds)
7. Ejecting Rod (ref. parameter 82)
8. Aligning
9. Stepping Motor
10. Reserved
11. Reserved
12. Speed Controller Voltage (ref. parameter 82)
Stimulated mechanism adjustment for seam thickness
Presser Foot Magnetic Setting.
DO NOT CHANGE
The motion cycle of the presser foot electromagnet
Protecting functions when the presser foot
electromagnet activates.
Set the protection time when the presser foot
electromagnet performs.
When #38 FMM is set ON (presser foot Up), set the
delay time to lower the presser foot.
Set the time of delaying as half pedaling
Set the time to start motor after presser foot down.
ON: Enable (When removing the proximity switch,
stop all functions and motors)
OFF: Disable
To save the last error codes up to 10 sets
P9