Siruba ASK-ASM100 Instruction Book / Parts List page 18

Parameter List
※ DO NOT CHANGE THOSE PARAMETERS THAT MARKED "DO NOT CHANGE" !
※ Some parameters require passwords. Refer to instruction above for passwords input.
Item Code Function
1 H Speed Adjustment
Selection of slow start
2 LMS
function
3 L Slow Start speed
Stitch setting of slow
4 LSS
start
Selection of stitch
5 KMS
counter mode
Setting of counter
6 KT
target value
7 KV Counter display
Machine speed
8 SV
display
9 TMD Sewing Mode select
Setting of motor rotary
10 MRM
mode
11 AA Stepping Motor Delay
12 BB Stretching wheel delay 0000 ~9999
13 CC Presser Foot delay
Overlapping sewing
14 DD
stitch
15 EE Loose stop stitch
16 FF Ejecting Rod timer
Ejecting Rod delay
17 GG
time
Suction, Cut and loose
18 HH
Stitch
19 IRD Stepping motor speed
20 BIR Double overlapping
Unload materials, air
21 SS
blow time
22 SWC Suction Mode
23 FOR Lever back delay time
P8
Range Default Unit
200~5500 3000 rpm
ON/OFF OFF //
200~5500 3000 rpm
1~100 30 STH
NOP/UTS NOP //
1~9999 99 time
1~9999 0 time
200~5500 0 rpm
NOP:
Ordinary
sewing
CUF //
CUF: Cuff
PAN: Trouser
bottom
NOP/MA MA //
0000 ~9999 1 ms
5 ms
0000
10
~9999
0000 ~9999 20
0000 ~9999 15
0000 ~9999 1000 ms
0000 ~9999 75 ms
0000 ~9999 50
320~800 350
ON/OFF ON
0-200 2
1/2/3/4/5 4
0000 ~9999 150
Description
Setting limited by the highest speed limit "56.HL.＂
ON: turn on
OFF: turn off
Setting of starting sewing speed
Setting of stitches
NOP: deactivate UTS: activate
Setting of target counter numbers
Instantaneous display
Instantaneous display the motor exact rotary speed.
NOP: Ordinary sewing CUF: Cuff PAN: Trouser
bottom
The sewing mode selection will not being influenced
by pressing arrow key
setting-up
MA: Manual
Setting the time to enable the stepping motor after
pressing the start switch.
Setting the time to enable the stretching wheel
solenoid valve after pressing the start switch.
Setting the time to enable Presser Foot after pressing
the start switch.
Setting the stitch number after sensor detects the
seam.
Setting the stitch number to disable the Loose Stop
after motor starts. (Loose Stop enable as default)
Set the running time of ejecting rod.
Set the time to enable ejecting rod after cross seam
sensor activates.
Set the stitch to run suction, cutting, and loose stitch
after parameter#14.
OFF: Enabling the Cutting & Suction after once
overlapping
ON: Enabling the Cutting & Suction after twice
overlapping
1. No suction 2. Only Front suction
3. Only Back suction 4. Front and Back suction
5. Mechanical suction(only for manual mode)
to back to default