Table of Contents
Advertisement
3.3 Hardware Installation
WARNING:
DO NOT install the Mustang-V100-MX4 into the TANK AIoT Dev. Kit
before shipment. It is recommended to ship them with their original
boxes to prevent the Mustang-V100-MX4 from being damaged.
To install the Mustang-V100-MX4, please follow the steps below.
Step 1:
Prepare the computer. Turn off the computer, and remove the power cord from
the rear of the power supply.
WARNING:
Disconnect the computer from the power supply and from any networks
to which you will install the Mustang-V100-MX4, or you risk damaging
the system or experiencing electrical shock.
Step 2:
Remove the cover from the chassis.
Step 3:
Locate available PCIe slots and remove the blank brackets. The
Mustang-V100-MX4 is compatible with PCIe x2 slots, and only needs one PCIe
slot for installation. Remove a blank bracket panel on the back of the computer
that aligns with the PCIe slot for installing the Mustang-V100-MX4. Save the
bracket screw.
Page 12
Mustang-V100-MX4
Advertisement
Table of Contents
