IEI Technology Mustang-V100-MX4 User Manual page 33

Mustang-V100-MX4
xternal/hddl
sudo chmod +x ./generate_udev_rules.sh
sudo ./generate_udev_rules.sh /etc/udev/rules.d/98-hddlbsl.rules
5. Check if the file /etc/modprobe.d/blacklist.conf contains the line "blacklist i2c_i801"
and comment it out if so:
sudo sed -i "s/\(.*i2c_i801$\)/#\1/g"
/etc/modprobe.d/blacklist.conf
sudo modprobe i2c_i801
6. Before you start installing the drivers, make sure there is no inference application is
running. Use the following command to make sure there is no HDDL service is
running:
kill -9 $(pidof hddldaemon autoboot)
7. Install the drivers:
cd
/opt/intel/openvino_<version>/deployment_tools/inference_engine/e
xternal/hddl
sudo chmod +x ./setup.sh
sudo ./setup.sh install
sudo cp -av
/opt/intel/openvino_<version>/deployment_tools/inference_engine/e
xternal/hddl
sudo cp -av
/opt/intel/openvino_<version>/deployment_tools/inference_engine/e
xternal/hddl
sudo udevadm control --reload-rules
sudo udevadm trigger
sudo ldconfig
Now, the Mustang-V100-MX4 drivers are installed.
8. Modify the device number on your host
Change the total device numbers of "hddl_autoboot.config".
Each Mustang-V100-MX4 contains 4 devices, therefore, user has to change device
number from default 8 to 4.
/drivers
/}/../97-myriad-usbboot.rules /etc/udev/rules.d/
/etc /
Page 25