IEI Technology Mustang-V100-MX4 User Manual page 19

Mustang-V100-MX4
WARNING:
The installation instructions described in this manual should be carefully
followed in order to prevent damage to the Mustang-V100-MX4, its
components and injury to the user.
Before and during the installation please DO the following:
Read the user manual:

The user manual provides a complete description of the Mustang-V100-MX4
installation instructions and configuration options.
Wear an electrostatic discharge cuff (ESD):

Electronic components are easily damaged by ESD. Wearing an ESD cuff
removes ESD from the body and helps prevent ESD damage.
Turn off system:

When installing the Mustang-V100-MX4, make sure that the system to be
connected is disconnected from all power supplies and that no electricity is
being fed into the system.
Before and during the installation of the Mustang-V100-MX4 DO NOT:
Remove any of the stickers on the PCB board. These stickers are required for

warranty validation.
Use the product before verifying all the cables and power connectors are

properly connected.
Allow screws to come in contact with the PCB circuit, connector pins, or its

components.
Page 11